Occupational Health and Safety

​Teknokon Makina gives occupational health and safety the first priority in all its organizational levels as part of its values, ethics and strategies.

OHS Planning

Teknokon Makina gives occupational health and safety the first priority in all its organizational levels as part of its values, ethics and strategies.
 
Teknokon Makina, having OHSAS 18001 certification, will follow these OHS steps within the scope of any project that it will undertake;
 
•   OHS Plan
•   Emergency Response Plan
•   Risk Assessments
•   Roles and Responsibilities
•   OHS Communication Procedure
•   OHS Operating Procedures
•   Continuous Improvement Studies
 
Teknokon Makina revises the plans and procedures listed above in accordance with the project conditions, requirements, specifications and needs in order to make them suitable for project requirements.

 

OHS Implementation and Operation

Teknokon Makina has established a follow-up systematic to ensure the feasibility of the plans, procedures and operations.
 
In order any work to be done in the workplace to be understood by all concerned employees and to eliminate any possible risks beforehand, relevant trainings are organized and the work permit mechanisms are applied in the works that are considered as risk.

 
Specific Work Hazard Analysis
In addition to risk analysis for each potentially dangerous work types, Teknokon Makina conducts a project specific work hazard analysis when necessary.
 
Training Programs
Teknokon Makina recognizes that continuous training is an essential rule in parallel with the philosophy that every accident is preventable.
 
For this reason, every employee has an effective training throughout their career from the first day of employment. Training activities are planned and implemented not only in terms of OHS performance, but also for the purpose of establishment of a culture of occupational safety.

 
OHS Communication (Meetings, Notifications,  Warnings)
Effective and timely communication is an important component of our OHS Management System.
 

OHS Control and Monitoring

Teknokon Makina OHS performance is monitored through internationally accepted parameters. The OHS performance is regularly audited by the OHS department and the relevant organizations and the results of these audits are evaluated by both the fabrication plant management and the company management. The followiing periodic audits are conducted and reported:
 

•   OHS Non-Conformance Assessments and Action Plans
•   OHS Factory Audit
•   OHS Performance Measurement
•   Legal Compliance Control
 

Measurement, Analysis and Improvement

All kinds of internal and external audits, project data and training reports are analyzed in detail. It is an important part of our OHS Management System to prevent the repetition of any defects discovered as a result of these analyses. For this purpose, all accidents and incidents are investigated in detail in order to determine the root causes. Thus, all accidents and events are investigated in detail in order to determine the root causes. Corrective and Preventive Actions resulting from these investigations are shared with the entire Teknokon Grup Organization in order to take the necessary measures. The Corrective Preventive Actions are also a part of the periodic Board of Directors report, which ensures the involvement of the top management.